errata

While I do everything possible to ensure that my patterns contain no errors, sometimes they manage to sneak past me and my tech editor. Corrections for those errors can be found below.

-

ELAM

Version 1 of this pattern (versions downloaded prior to October 28, 2014) had a mistake in Round 6 of the crown decrease section. This round should read:

Rnd 6: [P1, k1, s2kp2, k1] around. 40 sts remain.

This correction has been made in version 2 of the pattern.

-

ELSKLING

Version 1 of this pattern (versions downloaded prior to August 3, 2015) had a mistake in Row 1 (Decrease row) of the second section of the Raglan Shaping. This row should read:

Row 1 (Decrease row): *K1, k2tog, k to 3 sts before m, ssk, k1, sm, k to Lace Panel, work Lace Panel sts, k to m, sm. Rep from * once more, then k1, k2tog, k to last 3 sts, ssk, k1. 6 sts decreased.

The "k2tog" in bold text was originally missing. This correction has been made in version 1.1 of the pattern.

-

MOON PULLS

January 16th, 2014: One correction for the Raglan Shaping section (page 5 of pdf): the needle size listed for the Set-Up Round should be Size A, not Size B 

-

PINE BOUGH COWL

Where the pattern reads:

Rep Chart A, Chart B and Stripe Section 2 three times for a total of four times.

This incorrectly omits Stripe Section 1, and so it should read:

Rep Chart A, Stripe Section 1, Chart B, and Stripe Section 2 three times for a total of four times.

-

SALTSTRAUMEN

The following two sections were omitted from the pattern by mistake:

ABBREVIATIONS

k knit
p purl
k2tog knit two together
ssk slip slip knit
p2tog purl two together
2/1 LPC (2 over 1 right purl cross): Slip 1 stitch to cable needle, hold to back, k2, p1 from cable needle
2/1 RPC (2 over 1 left purl cross): Slip 2 stitches to cable needle, hold to front, p1, k2 from cable needle
2/2 RC (2 over 2 right cross): Slip 2 stitches to cable needle, hold to back, k2, k2 from cable needle
2/2 LC (2 over 2 left cross): Slip 2 stitches to cable needle, hold to front, k2, k2 from cable needle
2/2 RPC (2 over 2 right purl cross): Slip 2 stitches to cable needle, hold to back, k2, p2 from cable needle
2/2 LPC (2 over 2 left purl cross): Slip 2 stitches to cable needle, hold to front, p2, k2 from cable needle

PATTERN BEGINS

Using the long tail cast on and circular needle, cast on 140 stitches. Place marker for beginning of round and join to work in the round, being careful not to twist.

Round 1: P1, [k2, p2] 8 times, k2, place marker, [k2, p2] 17 times, k2, place marker, [k2, p2] 8 times, k2, p1.

Repeat round 1 four more times, slipping markers as you come to them.

Begin working Chart. Each row of the Chart is worked twice per round. Change to DPNs when necessary after the decreases begin.

Upon completion of Chart, 40 stitches remain.

Next round: K2tog around. 20 stitches remain

Next round: K2tog around. 10 stitches remain

Break yarn and using a tapestry needle, thread through remaining 10 loops, pulling tight to close the hole.

Weave in all ends and block.